apache搭建svn版本库教程详解

# dav_svn.conf - Example Subversion/Apache configuration
#
# For details and further options see the Apache user manual and
# the Subversion book.
#
# NOTE: for a setup with multiple vhosts, you will want to do this
# configuration in /etc/apache2/sites-available/*, not here.

# <Location URL> ... </Location>
# URL controls how the repository appears to the outside world.
# In this example clients access the repository as http://hostname/svn/
# Note, a literal /svn should NOT exist in your document root.
<Location /svn>
# Uncomment this to enable the repository
DAV svn

# Set this to the path to your repository
# SVNPath /home/svn
# Alternatively, use SVNParentPath if you have multiple repositories under
# under a single directory (/var/lib/svn/repo1, /var/lib/svn/repo2, ...).
# You need either SVNPath and SVNParentPath, but not both.
SVNListParentPath on
SVNParentPath /home/svn

# Access control is done at 3 levels: (1) Apache authentication, via
# any of several methods.A "Basic Auth" section is commented out
# below.(2) Apache <Limit> and <LimitExcept>, also commented out
# below.(3) mod_authz_svn is a svn-specific authorization module
# which offers fine-grained read/write access control for paths
# within a repository.(The first two layers are coarse-grained; you
# can only enable/disable access to an entire repository.)Note that
# mod_authz_svn is noticeably slower than the other two layers, so if
# you don't need the fine-grained control, don't configure it.

# Basic Authentication is repository-wide.It is not secure unless
# you are using https.See the 'htpasswd' command to create and
# manage the password file - and the documentation for the
# 'auth_basic' and 'authn_file' modules, which you will need for this
# (enable them with 'a2enmod').
AuthType Basic
AuthName "Subversion Repository"
AuthUserFile /etc/apache2/dav_svn.passwd

# To enable authorization via mod_authz_svn
AuthzSVNAccessFile /etc/apache2/dav_svn.authz

# The following three lines allow anonymous read, but make
# committers authenticate themselves.It requires the 'authz_user'
# module (enable it with 'a2enmod').
#<LimitExcept GET PROPFIND OPTIONS REPORT>
Require valid-user
#</LimitExcept>

</Location>

[groups]
haotest1-admin=wangzhengyi
haotest1-dev=wangzhengyi,chenshan

[haotest1:/]
@haotest1-dev=r
@haotest1-admin=rw

[haotest1:/trunk]
@haotest1-dev=rw

[haotest1:/tags]
@haotest1-admin=rw